BL-CB33-0115 - 03-01-2018 9-3
9-3. Lift Cylinder (Telescopic)
9-3.1. Removal
1. Fully lower the lift carriage.
2. Turn off the key switch and disconnect the batteries.
WARNING: Before attempting any replacement, make certain
power is disconnected.
3. Remove screw, lock washer and flat washer, securing the
top of cylinder to mast.
4. Using another lift truck or suitable jack, raise mast far
enough to remove pressure on the lift cylinder.
CAUTION: Hydraulic oil can damage parts. Wipe off any oil
immediately. Provide a container under the line or
fitting before disconnecting.
5. Disconnect the tube from the bottom of lift cylinder.
6. Support cylinder and remove two bolts , two lock washers ,
two flat washers, shims, bracket, clip and block.
7. Raise lift cylinder assembly up and out of truck.
Figure 9-2 Lift System (Telescopic)
DP_0019
DP_0037
With Side Shift
Without Side Shift
To Next Page
Loading...
