UF V (E3) 03/2019 Page 14/116
1.8 Measures to prevent accidents
The operator of the chamber must observe the following regulation: Occupational Safety Regulations.
Operation of refrigeration chambers, heat pumps and cooling systems (GUV-R 500 chap. 2.35) (for Ger-
many).
Following measures have been taken by the manufacturer in order to prevent ignition and explosions:
• Indications of the type plate
See operating manual chap. 1.4
• Operating manual
An operating manual is available for each chamber.
• Temp eratu re mo nitoring
The chamber has a temperature display which can be read from outside.
An additional temperature safety device is built into the device. A visual and an audible signal (buzzer)
show exceeding of the temperature.
• Safety, measurement and control devices
The safety, measuring, and control devices are easily accessible.
• Electrostatic charge
The interior parts are grounded.
• Non-ionizing radiation
Non-ionizing radiation is not intentionally produced, but released only for technical reasons by electrical
equipment (e.g. electric motors). The machine has strong permanent magnets. If persons with active
implants (e.g. pacemakers, defibrillators) keep a safe distance (distance of field source to implant) of
30 cm, an influence of these implants can be excluded with high probability.
• Protection against touchable surfaces
Tested according to EN ISO 13732-3:2008.
• Floors
See operating manual chap. 3.4 for installation
• Cleaning
See operating manual chap. 24.3.
DOMINIQUE DUTSCHER SAS
To Next Page
Loading...
