Biotage Selekt - Base a New Run on a Previous Run

 Biotage
®
Selekt User Manual | © Biotage 2020
Results
Export the Report to a USB Memory Device
1. Connect the USB memory device to a USB port on the left
side of the system.
2. Select the desired report in the Results view.
3. Select whether to export the full Selekt report or a
customized version by turning the Apply Report Setup option
off or on. To customize the report, see page 21.
4. Press Export.
5. If the Export dialog opens, press Export again. The report is
saved as a PDF file at \biotage\selekt\
user name . The result
files are saved at \biotage\selekt\results.
6. When the export has been completed (
), remove the USB
memory device.
Send the Report in an E-mail
Note: This option is only available when the system is
connected to an e-mail server.
1. Select the desired report in the Results view.
2. Select whether to export the full Selekt report or a
customized version by turning the Apply Report Setup option
off or on. To customize the report, see page 21.
3. Press Export.
4. In the Export dialog, select your user name in the User
drop-down list and press Send.
Note: Only users with a registered e-mail address are listed
in the User drop-down list.
5. When the e-mail has been sent (
), press Close.
Base a New Run on a Previous Run
To create a new run with the same purification parameters as
in a previous run:
1. Select the run to base the next run on.
2. Press Create Run and then select Channel 1 or Channel 2 in
the appearing dialog.