CE Mark | xiii
MicroFlo Select Operator's Manual
Directive 2004/108/EC: Electromagnetic Compatibility
Emissions - Class A
The system has been type-tested by an independent, accredited testing laboratory
and found to meet the requirements of EN 61326-1 and EN 61326-2-6: Class A for
Radiated Emissions and Line Conducted Emissions.
Verification of compliance was conducted to the limits and methods of EN 55011 –
(CISPR 11) Class A. In a domestic environment it may cause radio interference, in
which case you may need to mitigate the interference.
Immunity
The system has been type tested by an independent, accredited testing laboratory
and found to meet the requirements of EN 61326-1:2003 and CISPR 16-2:1999 for
Immunity. Verification of compliance was conducted to the limits and methods of
the following:
EN 61000-4-2 Electrostatic Discharge
EN 61000-4-3 Radiated EM Fields
EN 61000-4-4 Electrical Fast Transient/Burst
EN 61000-4-5 Surge Immunity
EN 61000-4-6 Conducted Disturbances
EN 61000-4-11 Voltage Dips, Short Interruptions and Variations
Directive 73/23/EEC: Low Voltage (Safety)
The system has been type tested by an independent testing laboratory and was found
to meet the requirements of EC Directive 73/23/EEC for Low Voltage. Verification of
compliance was conducted to the limits and methods of the following:
EN 61010-1
(2001) 2nd Edition
“Safety requirement for electrical equipment for measurement, control and laboratory
use. Part 1, General requirements.”
EN 61010-2-81 (2003)
“Requirements for automatic and semi-automatic laboratory equipment for analysis
and other purposes.”
EN 61010-101 (2002)
“Particular requirements for in vitro diagnostic (IVD) medical equipment”
Directive 2002/96/EC: Waste Electrical and Electronic Equipment
Disposal Notice: This instrument contains printed circuit boards and wiring with lead
solder. Dispose of the instrument according to Directive 2002/96/EC, “on waste
electrical and electronic equipment (WEEE) or local ordinances.”
To Next Page
Loading...