94 | Error Codes
BioTek Instruments, Inc.
Software Error Codes
The following error codes are displayed when using the LHC software to control the
MicroFlo.
Error Code Description
6000 General communication error during download.
6001 COM port created by USB converter no longer active.
6010 The data is invalid or out-of-range.
6011 This step type can not be downloaded.
6012 Illegal characters in protocol name; valid characters are letters,
numbers, spaces, or _-%&
6013 The protocol name length must be 16 characters or less.
6014 A 1536 well plate is not supported by this instrument.
6015 The specified volume exceeds the cassette maximum limit.
6016 The Volume is out-of-range.
6017 Invalid Flow rate.
6018 Invalid number of pre-dispenses.
6019 Invalid Horizontal dispense position.
6020 Invalid dispense height.
6021 Invalid plate clear height.
6022 Invalid column selection value (must be 0 or 1).
6023 Invalid protocol step type.
6024 The definition string contains invalid data.
Communication Errors
6040 Invalid baud rate
6041 Invalid data bits selection
6042 Invalid stop bits selection
6043 Invalid parity selection
6044 Serial port error
6045 Serial write error
6046 Serial read error
6047 Checksum error
6048 Serial NAK error
6049 Excess data, or not enough data, received
6050 Invalid message header
6051 Invalid message object
6052 Invalid message body size
6053 Serial message timeout
6054 Port handle error
6055 Read timeout value is invalid
6056 Unauthorized to open the COM port
6057 Out of range parameter for the open port function
6058 Unable to open the COM port
6059 Unable to clear the transmission buffer
6060 Unable to close the port
6061 Port is no longer available
To Next Page
Loading...