sat801+ Pulse Oximeter
Technical data
13
NOTICE!
A functional tester cannot be used to assess the accuracy of a pulse oximeter probe or a
pulse oximeter
.
NOTICE!
If there is independent demonstration that a particular calibration curve is accurate for the
combination of a pulse oximeter and a pulse oximeter probe, then a functional tester can
measure the contribution of a monitor to the total error of a monitor/probe system. The
functional tester can then measure how accurately a particular pulse oximeter is
reproducing that calibration curve
.
Perfusion
Display range 0.02-20.0 %
Setting range of the alarm limits
Upper Limit oxygen saturation 42-100 %
Lower Limit oxygen saturation 40-98 %
Upper Limit pulse frequency 27-240 1/min
Lower Limit pulse frequency 25-238 1/min
Alarm tone loudness 75 dbA
Sensor
Wavelengths 660 nm (red), 905 nm (infrared)
max. light intensity 0.79 mW
Notice!
Information about wavelength range can be especially useful to clinicians.
To Next Page
Loading...
