Bitmos sat801+ - Use; 6.1 Environmental Conditions; 6.2 Prior to initial use; 6.3 Energy supply

sat801+ Pulse Oximeter
Use
21
6 Use
6.1 Environmental Conditions
The unit uses high frequency energy exclusively for its internal functions. That is why its high
frequency emission is very low and it is improbable that electronic units in close vicinity can be
disturbed.
The unit is intended for use in all environments including homes and those directly connected to a
public service network, which also serves buildings with living spaces.
Floors should consist of wood or cement or be covered with ceramic tiles. If the flooring is
covered with synthetic materials the relative humidity has to be at least 30%.
6.2 Prior to initial use
Before using the unit for the first time, familiarize yourself with it and its accessories. This
absolutely includes reading the user manual.
WARNING! Danger to the Patient!
The unit is used to monitor patients. That is why it should only be used and
configured by trained and instructed users.
Before using the unit on a patient for the first time, it must be turned on and tested.
6.3 Energy supply
6.3.1 Mains connection
Electricity for the unit can be provided by the accompanying power pack plug or with batteries for
mobile use.
If during use the unit is disconnected from the electrical supply, the network failure alarm
activates.
ATTENTION!
Never use multiple electric socket strips to supply the unit.
Never connect the unit to a switched network socket.
Only use the power pack plug supplied with the unit.
Install the unit in an way that the unit can be easily disconnected from the power
supply.