The following pages will review the Blustream Multicast PC program and Web GUI interface, giving the installer the
knowledge to completely configure a full Blustream HDMI over IP system.
Prior to running the Blustream Multicast PC configuration soware it is important that you have the following hardware
available:
• PC with active LAN Network connection
• CAT network cables - straight connection
• Layer 3 managed network switch (POE) OR 24-56V DC power supply to power the units locally
Multicast PC Program
Supporting Documentation & Downloads
The relevant supporting for the Blustream Multicast products can be found on the Blustream website:
www.blustream.co.uk/ip100uhd
Click on the ‘Drivers & Protocols’ download button located on the individual Multicast product webpage:
This link will give access to the following information / documentation:
- IP100UHDTX/RX Firmware - this will always be the most current version of firmware available
- CM100 Documentation - firmware, 3rd party control drivers
- Multicast PC Program download (.exe format)
- Multicast Documentation
- Network Switch Instructions (Cisco, Luxul, etc)
To Next Page
Loading...
