Our UHD Multicast distribution platform allows virtually latency free (1 frame) distribution of HDMI video over a 1GB
Network switch. The IP100UHD-TX/RX oer industry leading 4K HDCP 2.2 HDMI distribution using a visually lossless
compression technology, delivering HDMI, IR and RS-232 over standard network architecture. The CM100 Control
Module allows simple third party control of the Multicast system using TCP/IP, RS-232 or IR. The Blustream Multicast
products can be powered via PoE from a Network switch or locally should the switch not support PoE.
With multiple configuration options available the Multicast solution is ideal for both commercial and residential
installations. Furthermore the system wizard PC configuration program and pre-built Blustream product drivers
simplify Multicast product installation and negate the need for an understanding of complex network infrastructures.
Introduction
Please Note:
The Blustream Multicast system distributes HDMI video over layer 3 managed network hardware. It is advised that
Blustream Multicast products are connected on an independent network switch to prevent interference or drop in
signal performance due to other network products.
Please take care to make sure that you have read and understood the instructions in this manual and that you have
setup your network switch correctly prior to connecting any Blustream Multicast products. Failure to do so will result
in problems with configuration of the system and video performance.
• Advanced UHD video over 1GB Network
• Virtually unlimited system size
• Extends HDMI over network architecture
• Compatible with all common brands of layer 3 managed network switches
• Supports up to 4K HDR UHD video (3840 x 2160 @30Hz 4:4:4, 4096 x 2160 @24Hz 4:4:4, and 4K @60Hz 4:2:0)
• Supports all known HDMI audio formats including Dolby TrueHD, Dolby Digital Plus and DTS-HD Master Audio transmission
• Features 4 operational modes:
- Matrix distribution (Requires 1GB network switch)
- Video wall (Requires 1GB network switch)
- One-to-one HDMI extender (No network switch required)
- One-to-many HDMI extender (No network switch required)
• HDCP 2.2 Compliant
• Advanced EDID management
• Video up-scaling and down-scaling
• Analogue L/R audio embedding on IP100UHD-TX Transmitter
• Analogue L/R audio breakout on IP100UHD-RX Receiver
• Bi-directional RS-232 and IR pass through
• PoE (Power over Ethernet) to power Blustream products from PoE switch
• Local 24-56V power supply (should Network switch not support PoE). Sold separately
• RS-232, IR and Telnet/IP integration for control of Multicast system using Blustream CM100
• 3rd Party drivers available for all major home control brands
Features
To Next Page
Loading...
