Surge protection device recommended
This product contains sensitive electrical
components that may be damaged
by electrical spikes, surges, electric
shock, lightning strikes, etc. Use of
surge protection systems are highly
recommended in order to protect and
extend the life of your equipment.
Contents
Thank you for purchasing this product
For optimum performance and safety,
please read these instructions carefully
before connecting, operating or adjusting
this product. Please keep this manual for
future reference.
Introduction 04
Features 04
Panel Description - IP100UHD-TX Transmitter 05
Panel Description - IP100UHD-RX Receiver 06
Panel Description - CM100 Control Module 07
HDMI Over IP Network Configuration 08
Understanding Product Status Lights 09
Audio Connections 09
Infrared Control 10
Remote Control - REM100 10
Infrared Distribution 11
Infrared Pass-Through (Source Control) 12
RS-232 (Serial) Bi-Directional Pass-Through 13
Guest Mode - Telnet/IP Conversion To RS-232 14
Manual Configuration (without PC) 15
EDID Settings 16
Scaler Output Settings 17
Multicast PC Program 18
Supporting Documentation & Downloads 18
IP100UHD Firmware Update 19
IP100UHD Firmware Update via PC Program 20
PC Program Main Menu Overview 21
New Project Configuration 22-27
Safety And Performance Notice
The transmission distances of HDMI
over UTP cables are measured using TE
CONNECTIVITY 1427071-6.
EIA/TIA-568-B termination (T568B) of
cables is recommended for optimal
performance.
To minimise interference of the unshielded
twisted pairs in the CAT5e/6/6a cable do
not run the Cat5e/6/6a cabling with or in
close parallel proximity to mains power
cables.
Do not substitute or use any other power
supply other than approved PoE network
products or approved Blustream power
supplies.
Do not disassemble any Blustream
Multicast products for any reason. Doing so
will void the manufacturer’s warranty.
To Next Page
Loading...
