8 | First Steps
28/144 Manual_C_80 Bosch Motorsport
A mounting location must not be used several times in one network, this would disturb
the functionality of the respective C 80.
1. In the Project Tree right click on the project name e.g. ‘New Project’ and then select
‘Show discovered devices…’.
All connected C 80 are listed.
2. Compare the listed device Type, FNumber and SNumber to the identification plate to
identify the device you want to make changes to:
3. Assign the desired mounting location (e.g. ‘Front’) and confirm by clicking ‘Apply’.
To Next Page
Loading...
