Bosch C 80 User Manual

15 | Telemetry System LTE 65
100/144 Manual_C_80 Bosch Motorsport
an incremented file name. Retaining all of these *.ini file iterations will ensure that
WDServer always has a reference to whichever configuration is programmed into your
vehicle’s logger system.
– If the RaceCon project for the vehicle resides on a different computer, than that which
is used for telemetry, then all *.ini files for a given project should be transferred to the
telemetry computer after every data synchronization in RaceCon. WDServer may have
trouble recognizing *.ini files stored on removable media, so best practice is to copy
these files to the telemetry computer’s hard drive.
15.4 Loading the telemetry data
The following is an example of a file name and data format for Car #91. File is typically
located in WinDarab/Config/WDServer:
In the File Explorer, click ‘Open’ and navigate to the data set. Under ‘Network’, search for
the car or cars that are required for viewing.

Bosch C 80 Specifications

General

Resolution	16 bit
Interfaces	USB
Measurement Range	±10V
Accuracy	±0.1 % FS
Channels	8 universal analog inputs (±10 V, ±20 mA, Pt100, Pt1000, Thermocouples type K, S, J, T, N, R, B, E), 4 digital inputs (trigger, counter, frequency), 2 digital outputs (24 V / 500 mA)