Bosch Rexroth IndraMotion MTX micro - Page 157

Structure element Description
RetPaStrategy Approaching strategy after block pre-run
TargetBlkCheck Backed up point of interruption available
ManWaitForStart Manual data input after block pre-run
ReEntryStore Save program stack (call chain) at reset position
Tab. 12-7: Overview on the "SysSRun" structural elements
Active and preselected tool for
block pre-run "/SysToolSRun"
Structure element Description
ActTool.K1 Tool data element K1 of the active tool
ActTool.K2 Tool data element K2 of the active tool
ActTool.SKQ Tool data element SKQ of the active tool
ActTool.IKQ1 Tool data element IKQ1 of the active tool
ActTool.IKQ2 Tool data element IKQ2 of the active tool
ActTool.IKQ3 Tool data element IKQ3 of the active tool
ActTool.IQ1 Tool data element IQ1 of the active tool
ActTool.IQ2 Tool data element IQ2 of the active tool
ActTool.IQ3 Tool data element IQ3 of the active tool
ActTool.BQ1 Tool data element BQ1 of the active tool
ActTool.BQ2 Tool data element BQ2 of the active tool
ActTool.BQ3 Tool data element BQ3 of the active tool
PreTool.K1 Tool data element K1 of the prepared tool
PreTool.K2 Tool data element K2 of the prepared tool
PreTool.SKQ Tool data element SKQ of the prepared tool
PreTool.IKQ1 Tool data element IKQ1 of the prepared tool
PreTool.IKQ2 Tool data element IKQ2 of the prepared tool
PreTool.IKQ3 Tool data element IKQ3 of the prepared tool
PreTool.IQ1 Tool data element IQ1 of the prepared tool
PreTool.IQ2 Tool data element IQ2 of the prepared tool
PreTool.IQ3 Tool data element IQ3 of the prepared tool
PreTool.BQ1 Tool data element BQ1 of the prepared tool
PreTool.BQ2 Tool data element BQ2 of the prepared tool
PreTool.BQ3 Tool data element BQ3 of the prepared tool
TargEd Number of the active edge in the target block
TargDNr Number of the active D correction in the target block
TCorrNotAdj Tool correction not adjusted
Tab. 12-8: Overview on the structure elements "SysToolSRun"
Important system data for configuring the block pre-run
For more information, see the documentation "IndraMotion MTX Machine Pa‐
rameter", chapter "System data".
DOK-MTXMIC-EASY*******-CO06-EN-P Bosch Rexroth AG 155/177
IndraMotion MTX micro Easy Setup for Standard Turning and Milling Machines
Block search in MTX micro