Milling machine (HCQ) - Milling
Automation (HCT) - 3 axes
System axis Phys. Name Sercos address Connection
Dr[1] X 1 X5.1
Dr[2] Y 3 X5.3
Dr[3] Z 4 X5.4
Dr[4] - - -
Tab. 8-3: Predefined axis configurations
Fig. 8-9: Parameter axis assignment
The axis is assigned to a specific connection by changing the Sercos address
(MAIN/Dr[i]/Scs/ScsAddr).
Parameters for linear axes
Now set the traversing range limits, the velocity and the acceleration.
Relations are shown in the following figures:
Fig. 8-10: Schematic diagram 1
DOK-MTXMIC-EASY*******-CO06-EN-P Bosch Rexroth AG 95/177
IndraMotion MTX micro Easy Setup for Standard Turning and Milling Machines
NC parameterization
To Next Page
Loading...
