Bosch Rexroth IndraMotion MTX micro - Page 98

Fig. 8-11: Schematic diagram 2
Name Path
Positive max. traversing range AX/Dr[i]/Pos/TrvLim[1..2]/PoTrvLim I1
Negative max. traversing range AX/Dr[i]/Pos/TrvLim[1..2]/NeTrvLim I2
Maximum axis velocity AX/Dr[i]/Vel/MaxVel
Maximum acceleration AX/Dr[i]/Acc/MaxAxAxx
Tab. 8-4: NC parameter axes
Fig. 8-12: Parameter setting for axes: Traversing range, velocity, acceleration
Two traversing range limits TrvLim[1] and TrvLim[2] can be defined for each
axis. Switching between these two traversing ranges can be controlled via
the PLC. If only one traversing range is required, it is recommended to set
the two traversing ranges to the same limits.
Bosch Rexroth AG DOK-MTXMIC-EASY*******-CO06-EN-P96/177
IndraMotion MTX micro Easy Setup for Standard Turning and Milling Machines
NC parameterization