Broadcom Brocade 7850 - Port-Side View of the Device

7850-Install-IG101 Installation Guide Brocade
®
7850 Extension Switch Hardware Installation Guide
NOTE
•
8G requires a 32G optical transceiver.
•
ELWL requires a 64G ELWL Fibre Channel optical transceiver.
•
40GbE is supported through 4x 10GbE breakout using the SFP Ethernet ports. Where the 40GbE ports are
on the core router or WAN router and the 4x 10GbE breakout is on the Brocade 7850 Extension Switch.
Port-Side View of the Device
The following figure shows the port-side view of the Brocade 7850 Extension Switch.
Figure 1: Port-Side View
1. System Power LED
2. System Status LED
3. USB Port for Service
4. UART RJ-45 Serial Console Port
5. Management Ethernet Port
6. 8 SFP-DD FC ports (FC Ports 0–15)
7. 8 SFP+ FC ports (FC Ports 16–23)
8. 16 1/10/25G Ethernet ports (GbE Ports 0–15)
9. 2 100G Ethernet QSFP ports (GbE Ports 16–17)
7850-Install-IG101
10