7850-Install-IG101 Installation Guide
Brocade
®
7850 Extension Switch Hardware Installation Guide
Attaching the Front Brackets to the Rack
Perform the following steps to install the front brackets to the rack:
1. Position the device in the rack, providing temporary support under the device until the rack kit is fully secured to the
rack.
2. Attach the right front bracket to the right rack upright using two 10-32 x 5/8-in. screws and two retainer nuts. Use the
upper and lower holes in the bracket.
3. Attach the left front bracket to the left rack upright using two 10-32 x 5/8-in. screws and two retainer nuts. Use the
upper and lower holes in the bracket.
4. Tighten all 10-32 x 5/8-in. screws to a torque of 29 cm-kg (25 in.-lb).
Figure 24: Attaching the Front Brackets to the Rack
1. Screws, 10-32 x 5/8-in. Panhead Phillips
2. Retainer Nuts, 10-32
7850-Install-IG101
45
To Next Page
Loading...
