Broadcom Brocade 7850 - Attaching the Rear Brackets to the Device; MID-Mounting

7850-Install-IG101 Installation Guide Brocade
®
7850 Extension Switch Hardware Installation Guide
Attaching the Rear Brackets to the Device
Perform the following steps to attach the rear brackets to the device:
1. Align the right rear bracket to the right rear of the device and use four 8-32 x 5/16-in. panhead screws to attach the
bracket to the device. Be sure to insert the screws through the upper and lower slots in the bracket.
2. Align the left rear bracket to the left rear of the device and use four 8-32 x 5/16-in. panhead screws to attach the
bracket to the device. Again, use the upper and lower slots in the bracket.
3. Tighten all the 8-32 x 5/16-in. screws to a torque of 17 cm-kg (15 in.-lb).
Figure 22: Attaching the Rear Brackets to the Device
1. Screws, 8-32 x 5/16-in. Panhead Phillips
Mid-Mounting
Observe the following notes when performing this procedure:
•
The device must be turned off and disconnected from the fabric during this procedure.
•
The illustrations in this document show a 1U device, but the instructions are the same for a 2U device.
•
The illustrations in the rack installation procedures are for reference only and may not show the actual device.
7850-Install-IG101
43