7850-Install-IG101 Installation Guide
Brocade
®
7850 Extension Switch Hardware Installation Guide
Replacing an SFP-DD Transceiver
NOTE
Replacing an SFP-DD transceiver may cause disruption in the fabric or to the attached device.
Perform the following steps to remove an SFP-DD transceiver and then install a new SFP-DD transceiver.
1. Remove any cables that are inserted into the transceiver.
2. Grasp the SFP-DD transceiver pull tab, and pull the tab straight out.
NOTE
Grasp the tab near the body of the transceiver to reduce the chances of bending the pull tab. Avoid touching
the transceiver because it may be hot.
Figure 35: SFP-DD Transceiver
1. SFP-DD Transceiver
2. Dust Cap
3. Pull Tab of Transceiver in Upper Row
3. To insert the replacement transceiver, use the pull tab on the SFP-DD transceivers to help push the transceiver into
the port.
Transceivers are keyed so that they can be inserted only with the correct orientation. If a transceiver does not slide in
easily, ensure that it is correctly oriented. Push the correctly oriented transceiver into the port until it is firmly seated
and the latching mechanism clicks.
Insert the transceiver so that the pull tab is on the bottom.
7850-Install-IG101
64
To Next Page
Loading...
