Broadcom Brocade 7850 - Installing the Universal Two-Post Rack Kit (XBR-R000294); Time and Items Required

7850-Install-IG101 Installation Guide Brocade
®
7850 Extension Switch Hardware Installation Guide
Installing the Universal Two-Post Rack Kit (XBR-R000294)
Use the following instructions to install a Brocade 1U or 2U device in a two-post telecommunications (Telco) rack using the
Universal Two-Post Rack Kit (XBR-R000294).
You can mount the device in a two-post rack in two ways:
•
With the port side flush with the front posts
•
With the posts mounted to the mid-section of the device
Observe the following when mounting this device:
•
Two people are required to install the device in a rack.One person should hold the device, while the other person
screws in the front and rear brackets.
•
Hardware devices that are illustrated in these procedures are for reference only and may not depict the device that you
are installing into the rack.
Time and Items Required
The following items are required to install the device using the Universal Two-Post Rack Kit:
•
No. 2 Phillips torque screwdriver
•
1/4-in. slotted-blade torque screwdriver
7850-Install-IG101
37