Broadcom Brocade 7850 - Flush-Front Mounting

7850-Install-IG101 Installation Guide Brocade
®
7850 Extension Switch Hardware Installation Guide
Flush-Front Mounting
Observe the following notes when performing this procedure:
•
The device must be turned off and disconnected from the fabric during this procedure.
•
The figures in this document show a 1U device, but the instructions are the same for a 2U device.
•
The figures for this procedure show a two-post rack with narrow posts (3-in. to 5-in.) as an example.
•
The figures in the rack installation procedures are for reference only and may not show the actual device.
CAUTION
Use the screws specified in the procedure. Using longer screws can damage the device.
7850-Install-IG101
39