Broadcom Brocade 7850 - Installing the Device in the Rack

7850-Install-IG101 Installation Guide Brocade
®
7850 Extension Switch Hardware Installation Guide
Installing the Device in the Rack
Perform the following steps to install the device in the rack:
1. Position the device in the rack, providing temporary support under the device until the rail kit is secured to the rack.
2. Attach the right front bracket to the right rear rack post using two 10-32 x 5/8-in. panhead screws and two retainer
nuts. Use the upper and lower holes in the bracket.
3. Tighten all 10-32 x 5/8-in. screws to a torque of 29 cm-kg (25 in.-lb).
Figure 14: Positioning the Device in the Rack
1. Screws, 10-32 x 5/8-in. Panhead Phillips
2. Retainer Nuts, 10-32
7850-Install-IG101
33