Broadcom Brocade 7850 - Attaching the Rear Brackets to the Front Rack Posts

7850-Install-IG101 Installation Guide Brocade
®
7850 Extension Switch Hardware Installation Guide
Attaching the Rear Brackets to the Front Rack Posts
Perform the following steps to attach the rear brackets to the front rack posts:
1. Attach the right rear bracket to the right front rack post using two 10-32 x 5/8-in. screws and two retainer nuts. Use the
upper and lower holes in the bracket.
2. Attach the left rear bracket to the left front rack post using two 10-32 x 5/8-in. screws and two retainer nuts. Use the
upper and lower holes in the bracket.
3. Tighten all 10-32 x 5/8-in. screws to a torque of 29 cm-kg (25 in.-lb).
Figure 17: Attaching the Rear Brackets to the Front Rack Posts
1. Screws, 10-32 x 5/8-in. Panhead Phillips
2. Retainer Nuts, 10-32
7850-Install-IG101
36