7850-Install-IG101 Installation Guide
Brocade
®
7850 Extension Switch Hardware Installation Guide
Complete the following tasks to install the device in the rack:
1. Attaching the Front Brackets to the Device
2. Attaching the Front Brackets to the Rack
3. Attaching the Rear Brackets to the Rack
4. Attaching the Rear Brackets to the Device
Attaching the Front Brackets to the Device
Perform the following steps to attach the front brackets to the device:
1. Position the right front bracket with the flat side against the right side of the device.
2. Insert four 8-32 x 5/16-in. flathead screws through the vertically aligned holes in the bracket and then into the holes on
the side of the device. Use the upper and lower screw holes, leaving the center holes empty.
3. Repeat Steps 1 and 2 to attach the left front bracket to the left side of the device.
4. Tighten all the 8-32 x 5/16-in. screws to a torque of 17 cm-kg (15 in.-lb).
Figure 23: Attaching the Front Brackets
1. Brocade Device
2. Front Brackets, Right and Left
3. Screws, 8-32 x 5/16-in. Flathead Phillips
7850-Install-IG101
44
To Next Page
Loading...
