7850-Install-IG101 Installation Guide
Brocade
®
7850 Extension Switch Hardware Installation Guide
switchBeacon: OFF
FC Router: OFF
Fabric Name: FID1
HIF Mode: OFF
Allow XISL Use: ON
LS Attributes: [FID: 1, Base Switch: No, Default Switch: No, Ficon Switch: No, Address Mode 0]
Index Port Address Media Speed State Proto
==================================================
0 0 9c0000 id N64 Online FC F-Port 10:00:00:10:9b:8f:2d:1c
1 1 9c0100 id N64 Online FC F-Port 10:00:00:10:9b:8f:2d:1b
2 2 9c0200 id N64 Online FC F-Port 10:00:00:10:9b:8f:2d:e8
3 3 9c0300 id N64 Online FC F-Port 10:00:00:10:9b:8f:2d:e7
4 4 9c0400 id N64 Online FC F-Port 10:00:00:10:9b:8f:2c:e2
5 5 9c0500 id N64 Online FC F-Port 10:00:00:10:9b:8f:2c:e1
6 6 9c0600 id N64 Online FC F-Port 10:00:00:10:9b:8c:54:69
7 7 9c0700 id N64 Online FC F-Port 10:00:00:10:9b:8c:54:6a
(output truncated)
The tempshow command shows the current temperature of the EM sensors.
switch:admin> tempshow
Sensor ID|Sensor Index|State |Centigrade |Fahrenheit |
-------------------------------------------------------------
1 |0 |Ok |30 |86 |
2 |1 |Ok |34 |93 |
3 |2 |Ok |29 |84 |
4 |3 |Ok |30 |86 |
5 |4 |Ok |30 |86 |
6 |5 |Ok |32 |89 |
(output truncated)
Backing Up the Configuration
Back up the configuration regularly to ensure that a complete configuration is available for downloading to a replacement
switch.
Perform the following steps to back up the configuration:
1. Log on to the device as the admin user.
2. Back up the device configuration to an SFTP server by entering the configUpload command as shown in the
following example.
device:FID128:admin> configupload
Protocol (scp, ftp, sftp, local) [sftp]:
Server Name or IP Address [host]: 192.0.0.0
User Name [user]: MyUserID
Path/Filename [<home dir>/config.txt]: home/dumps/config.fid100.txt
Password: ***********
Section (all|chassis|FID# [all]):
configUpload complete: All selected config parameters are uploaded
2020/03/05-23:57:59, [CONF-1001], 130, FID 128, INFO, device, configUpload completed successfully for all.
This command uploads the device configuration to the server, making it available for downloading to a replacement
device if necessary.
7850-Install-IG101
54
To Next Page
Loading...
