7850-Install-IG101 Installation Guide
Brocade
®
7850 Extension Switch Hardware Installation Guide
4. Remove the first dust cap from the transceiver. Leave the second dust cap in place.
5. Position a cable so that the molded grid pattern and wide key tab on one side of the cable connector are facing up
(away from the transceiver pull tab).
Figure 36: Orientation of the SFP-DD Connector
6. Hold the white push-pull boot, and push the connector straight into the port on the transceiver until the latching
mechanism clicks.
The connector will make two soft clicks as it enters the port, and the wide key will fit into the key slot on the SFP-DD
transceiver.
NOTE
This photo is for illustration/instructional purposes only. This photo displays two rows of SFP-DD ports and
is used to illustrate installing an SFP-DD transceiver. However, the Brocade 7850 Extension Switch has one
row of SFP-DD ports only.
Figure 37: Installing an SFP-DD Connector
7850-Install-IG101
65
To Next Page
Loading...
