7850-Install-IG101 Installation Guide
Brocade
®
7850 Extension Switch Hardware Installation Guide
3. To insert the replacement transceiver, use the pull tab on the SFP+ transceiver to carefully push the transceiver into
the port. Transceivers are keyed so that they can be inserted only with the correct orientation. If a transceiver does not
slide in easily, ensure that it is correctly oriented.
NOTE
Each SFP+ transceiver has a 10-pad gold-plated PCB-edge connector on the bottom. The correct position
to insert an SFP+ transceiver into the upper row of ports is with the gold edge down. The correct position to
insert an SFP+ transceiver into the lower row of ports is with the gold edge up.
Figure 29: Installing SFP+ Transceivers
1. Pull Tab of Transceiver in Upper Row
2. Pull Tab of Transceiver in Lower Row
7850-Install-IG101
60
To Next Page
Loading...
