xi
Confidential
îš„ Federal Communications Commission (FCC) Declaration of Conformity
(U.S.A. only)
Responsible Party: Brother International Corporation
100 Somerset Corporate Boulevard
Bridgewater, NJ 08807-0911 USA
Tel: (908) 704-1700
declares, that the products
Product name: DCP-8110DN/DCP-8150DN/DCP-8155DN/
MFC-8510DN/MFC-8710DW/MFC-8810DW/MFC-8910DW/
MFC-8950DW/MFC-8950DWT
Model numbers: DCP-8110DN/DCP-8150DN/DCP-8155DN/
MFC-8510DN/MFC-8710DW/MFC-8810DW/MFC-8910DW/
MFC-8950DW/MFC-8950DWT
Product option: LT-5400
comply with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
• Call the dealer or an experienced radio/TV technician for help.
(Wireless network models only)
This transmitter must not be co-located or operated in conjunction with any other antenna or
transmitter.
Important
• Changes or modifications not expressly approved by Brother Industries, Ltd. could
void the user’s authority to operate the equipment.
• A shielded interface cable should be used to ensure compliance with the limits for a
Class B digital device.
To Next Page
Loading...
Need help?
General
