3-78
Confidential
(4) Remove the taptite flat B M3x10 screw from the inlet.
(5) Remove the screw pan M4x8, washer spring 2-4, washer 5, and remove the earth
harness from the machine.
(6) Remove the inlet and the power switch from the machine.
Fig. 3-106
Note:
• When removing the power switch, use a flathead screwdriver or similar tool to lift
the edge of the power switch to remove it.
Assembling Note:
• When attaching the power switch, align the marking on the power switch with the
engraved marking on the machine.
• Attach the inlet as shown in the illustration above.
• Insert the inlet harness into the housing of the machine.
Engraved
marking
Housing
Taptite flat B M3x10
Power switch
Earth harness
Inlet
Power switch
Marking
1
2
Screw pan M4x8
Washer 5
Washer spring 2-4
To Next Page
Loading...
