5-19
Basic printing procedures
(5) The T-shirt should be placed on the T-shirt tray, trying not to draw the excessive parts like sleeves and hems into
the printer.
(6)
On the operation panel, press , and move the platen toward the rear of the printer.
Try moving the platen, and check on the gap between the T-shirt surface and the obstacle sensor over the entire print area.
<TIPS>
If this gap is too wide, adjust the platen height.
Adjust the height so that it is lowered by one step from the limit height detected by the obstacle sensor, and check that the
platen is not detected by the sensor.
If the platen's height is too high, a print medium will strike against the print head during the printing process, which in turn
results in ink stains or malfunction.
(7)
On the operation panel, press , and move the platen toward the front of the printer.
<TIPS>
Repeat the height adjustment until the platen will be positioned at a proper height.
After your desired height is determined, start the printing operation. ☞"5-7. Executing a printing job >>P.5-29"
X104
X104
T-shirt
T-shirt tray
T-shirt
T-shirt tray
To Next Page
Loading...
