5-30
Basic printing procedures
5-7-2. Executing a print job several times for multiple print media
You can keep the identical print data and execute a print job several times for multiple print media.
<TIPS>
When the power is turned off, the retained print data is erased.
(1) Make sure that the print data you want to print out is displayed on the liquid crystal panel, and press and hold the
two print buttons at the same time to start printing. You will hear a sound each time you press the print buttons and
after a certain period lapses.
When the printing is completed, the platen moves to the forward-most position and the sound of "pong" is heard.
<TIPS>
If the print buttons are pressed when the platen has not moved toward the front, no print job will be started.
Pressing causes the printing to be canceled.
The number of print media of which printing is completed is shown on the liquid crystal panel.
The printer may shift to low temperature operation mode, when the room temperature is less than 18°C (64.4°F) and white
ink is used.
During low temperature mode, it may take a longer time for print operation and maintenance before starting the print.
Change the low temperature operation setting as needed. ☞"7-10. Print Operation Settings Under Low Temperature
>>P.7-8"
High-temperature and low-humidity environment may prolong the maintenance time after completion of printing. If any
warning message about temperature and humidity is displayed, be sure to control the temperature and humidity promptly
so as to conform with the print warranty scope. ☞"10-1. Apparatus >>P.10-1"
(2) Replace the platen's printed medium (T-shirt) with the next one and repeat the procedure until the desired number
of print jobs are completed.
To Next Page
Loading...
