Brother GTX600NB - Page 168

5-35
Basic printing procedures
Ink fixation by means of heat press
(1) Place the silicone foam, T-shirt and peel-off sheet in position under the heat press first, and fixate the ink properly.
<TIPS>
 For the guidelines on fixation conditions of ink, ☞"5-10. Fixation of ink >>P.5-34"
 For details, refer to the instruction manual of your heat press.
 There is a tendency to bring the print result to an almost matte finish if a silicone-coated paper is used as a peel-off sheet or
to an almost bright finish if a fluororesin sheet is used as the same at the ink fixation stage. Selectively use either of them
according to your desired finish.
Ink fixation by means of conveyor-type oven
(2) Fixate inks onto a T-shirt by means of the conveyor-type oven.
<TIPS>
 For the guidelines on fixation conditions of ink, ☞"5-10. Fixation of ink >>P.5-34"
 For the conveyor-type oven, identify the oven's internal temperature, and check up on actual ink fixation result.
 For details, refer to the instruction manual of your conveyor-type oven.
X011
5
X011
6
Heat press
Peel-off sheet
T-shirt
T-shirt
Conveyor-type oven
out in
Silicone foam