6-16
Precautions to keep good printing quality/use printer over the long term
<CAUTION>
Set the cap foam by aligning the cap foam hole with the protrusion on the backside of the cap rubber.
Be careful not to reverse the orientation of the cap foam.
The cap chip has two sides. Be careful not to turn it upside down.
Be careful not to turn the cap chip upside down when the cap chip and cap foam are assembled.
(7) Close the upper left-hand-side cover and top cover.
<NOTE>
Dispose of any waste resulting from the replacement in accordance with applicable laws and ordinances.
Back Surface
Cap chip
Cap foam hole
Cap foam
To Next Page
Loading...
