Brother GTX600NB - Page 287

9-16
Error message
Error code Error message Description
Remedy
6040 [Machine Error]
An error has been detected
in the print button on the right
side at the startup.
Make sure that the corresponding button is not
pressed.
If the problem persists, please contact your
dealer.
6041 [Machine Error]
An error has been detected
in the print button on the left
side at the startup.
Make sure that the corresponding button is not
pressed.
If the problem persists, please contact your
dealer.
6042 [Machine Error]
An error has been detected
in the platen stop button on
the right side at the startup.
Make sure that the corresponding button is not
pressed.
If the problem persists, please contact your
dealer.
6043 [Machine Error]
An error has been detected
in the platen stop button on
the left side at the startup.
Make sure that the corresponding button is not
pressed.
If the problem persists, please contact your
dealer.
6045 [Machine Error]
A panel board for a different
model is installed.
Restart the printer and update the firmware
again. Check if the firmware update file is for the
model of your printer.
If the problem persists, please contact your
dealer.
6046 [Machine Error]
The main board firmware and
panel board firmware are not
compatible.
Restart the printer and update the firmware
again. Check if the firmware update file is for the
model of your printer.
If the problem persists, please contact your
dealer.
6070 [Machine Error]
An error has been detected
in the connector connection
of the platen stop button on
the right side.
Check and see if any source produces a loud
noise near the printer.
If the problem persists even after reactivating
the printer, please contact your dealer.
6071 [Machine Error]
An error has been detected
in the connector connection
of the platen stop button on
the left side.
Check and see if any source produces a loud
noise near the printer.
If the problem persists even after reactivating
the printer, please contact your dealer.
6105 [Machine Error]
Carriage initialization has
been failed.
Check to see if something gets caught in the
carriage or any foreign object exists inside the
printer. Also, clean the printer interior.
If the problem persists, please contact your
dealer.
6109 [Machine Error] Printing stopped abnormally.
Check and see if any source produces a loud
noise near the printer.
If the problem persists even after reactivating
the printer, please contact your dealer.
6130
[Machine Error
Adjust CR]
Abnormal decrease in the
carriage speed has been
detected.
Clean the carriage.
If the problem persists, please contact your
dealer.
6131
[Machine Error
Adjust CR]
Abnormal decrease in the
carriage speed has been
detected.
Clean the carriage.
If the problem persists, please contact your
dealer.