HL-1850/1870N SERVICE MANUAL
7-5
Title & Subtitle Item to be Set Description
FONT SELECT
300DPI PRIORITY 3B PRIO=LOW*
The priority of selection for
300dpi bitmap fonts are
standard (=low).
3B PRIO=HIGH
The priority of selection for
300dpi bitmap fonts are higher
than scalable font. The
compatibility of font selection
manner with HP LaserJet 4 is
not maintained if you choose 3B
PRIO=HIGH.
FX/XL SCALE FONT SCAL.F=NORMAL*
Only similar size fonts are
selectable as scalable is
selected.
SCAL.F=ALL SIZE
All fonts are selectable.
FX/XL SCALE ITA. ITA=OBLIQUE*
Makes upright font oblique to
have italic as scalable font is
selected.
ITA=ITALIC SEL
Uses the italic font to have italic
as scalable font is selected.
exit FONT
PAPER&TRAY SIZE DEF PAPER=LT*
Printers to be shipped to USA
and Canada have the Letter
size setting by default.
DEF PAPER=A4
Printers to be shipped to the
other area than USA and
Canada have the A4 size setting
by default.
PARALLEL MENU
PARALLEL TIMING CDCC PSW=H*
BUSY signal gets high when
STROBE signal goes up. This
is chosen by default.
CDDC PSW=L
BUSY signal gets high when
STROBE signal goes down
(low).
STB/ACK DELAY CDCC BSSL=L*
ACK signal is sent out before
BUSY signal goes down. This
is chosen by default.
CDCC BSSL=H
ACK signal is sent out when
BUSY signal goes down.
exit PARALLEL
REPRINT ON/OFF REPRINT=ON*
Follows the user menus setting
which selects either enabling or
disabling reprint function.
REPRINT=OFF
Enables reprint function.
To Next Page
Loading...
