Brother HL-L3210CW - Page 304

App.2-1
Confidential
APPENDIX 2 DELETING USER SETTING
INFORMATION
The user setting information for the machine is stored in the main PCB. You can return this to
the default settings by following the procedure below.
<Operating Procedure>
HL-L3210CW/HL-L3230CDN/HL-L3230CDW (For models without touch panel)
(1) Press the [▲] or [▼] to select the “Initial Setup” option, and then press the [OK].
(2) Press the [▲] or [▼] to select the “Reset” option, and then press the [OK].
(3) Press the [▲] or [▼] to select the “Machine Reset” option, and then press the [OK].
(4) Press the [▲] to select the “Reset”.
(5) Press the [▲] to restart the machine.
HL-L3270CDW (For models with touch panel)
(1) Press the [Settings] > [All Settings] > [Initial Setup] > [Reset] > [Machine Reset].
(2) You will be asked to reboot the machine. Press the option in the table to reboot the
machine or to exit the process.
(3) Press the .
Option Description
Press Yes for 2 seconds Reboot the machine. The machine will begin the reset.
No The machine will exit without rebooting.
Note:
If you do not reboot your machine, the reset process will not finish and your
settings will remain unchanged.