Brother HL-L3210CW - Registration Mark Sensor L PCB; Registration Mark Sensor R PCB

3-82
Confidential
9.27 Registration mark sensor L PCB /
Registration mark sensor R PCB
(1) Turn the machine face up.
(2) Release the Registration mark sensor L harness and the Registration mark sensor R
harness from the securing fixtures.
(3) Release the Hook, and then remove the REGI stopper from the Registration mark sensor
ASSY in the direction of the arrow.
(4) Remove the Taptite bind S M3x5 screw to remove the Registration mark sensor ASSY.
Fig. 3-74
Harness routing: Refer to “7. Registration mark sensor ASSY, Eject sensor PCB”.
Registration mark sensor ASSY
Hook
Registration mark sensor R harness
Taptite bind S M3x5
REGI stopper
Registration mark sensor L harness
<Top side>