Brother HL-L3210CW - List of Maintenance Mode Functions

5-3
Confidential
1.2 List of Maintenance Mode Functions
* The maintenance mode functions shaded in the table can be used by end users.
Function
code
Function Refer to:
01 Initialize EEPROM parameters 1.3.1 (5-4)
03 Transition to shipping state 1.3.2 (5-5)
09 Monochrome print quality test pattern 1.3.3 (5-7)
10 Set worker switches (WSW) 1.3.4 (5-8)
11 Print worker switch (WSW) setting data 1.3.4 (5-10)
12 Check LCD operation 1.3.5 (5-11)
13 Check control panel key operation 1.3.6 (5-13)
25 Display software version 1.3.7 (5-14)
32 Check sensor operation 1.3.8 (5-15)
33 Display LAN connection status 1.3.9 (5-17)
45 Change USB No. return value / Switching dither pattern /
Switching of timing to execute auto registration / Adjust
left-end print position / Adjust upper-end print position /
Change of the transfer current setting / Change of ghost
reduction setting / Change of function switch / Change of
drum developing bias correction value in endurance
deterioration of drum / Switching of black toner discharge
compensation
1.3.10 (5-18)
46 Adjust printable range for each speed level 1.3.11 (5-25)
57 Check consumables function 1.3.12 (5-27)
61 Adjust touch panel 1.3.13 (5-30)
66 Adjustment of color registration
(Adjustment of inter-color position alignment)
1.3.14 (5-31)
67 Continuous print test 1.3.15 (5-35)
68 LED ASSY test pattern print 1.3.16 (5-39)
69 Print frame pattern (1-sided printing) 1.3.17 (5-40)
70 Print frame pattern (2-sided printing) 1.3.18 (5-41)
71 Color test pattern 1.3.19 (5-42)
72 Sensitivity adjustment of density sensor 1.3.20 (5-45)
73 Continuous adjustments of density / registration sensor 1.3.21 (5-46)
74 Configure for country / region and model 1.3.22 (5-47)
77 Print maintenance information 1.3.23 (5-49)
78 Check fan operation 1.3.24 (5-51)
80 Display machine log information 1.3.25 (5-52)
82 Display machine error code 1.3.26 (5-56)
83 Developing bias voltage correction 1.3.27 (5-57)
88 Reset counters for consumable parts 1.3.28 (5-58)
91 Initialize EEPROM parameters 1.3.1 (5-4)
99 Quit maintenance mode 1.3.29 (5-58)