5-5
Confidential
1.3.2 Transition to shipping state (Function code 03)
This function contains display soft switch Check SUM, change ON/OFF setting of special
function at start up and transfer to the shipping state. Display soft switch Check SUM is
function for sales correspondence or production process and not used for the service. Only
change ON/OFF setting of special function at start up and transfer to the shipping state can
used for the service.
■ Display soft switch Check SUM
< Function >
This function is to display soft switch check SUM such as FSW/USW/WSW etc. Only for soft
switch display and not used for the service.
This function is displayed on LCD after enter function code 03 as “1.SWSUM?”.
■ Change ON/OFF setting of special function at start up
< Function >
When this parameter is [FUNC_DISABLE], perform switching the shipping state from OFF to
ON (“
■ Transfer to the shipping state”). When this parameter is [FUNC_ENABLE], the
shipping state cannot be switched to ON. Originally, during product manufacturing, this
function switches whether to enable or disable the menu function displayed by the special
function at start up, and it is invalid ([FUNC_DISABLE]) when the users use the machine.
< Operating Procedure >
(1) For models with touch panel
Press the [0], and then the [3] in the initial state of maintenance mode. “1.SWSUM?” is
displayed on the LCD.
For models without touch panel
Press the [▲] or [▼] in the initial state of maintenance mode to display “MAINTENANCE
03” on the LCD, and press the [OK]. “1.SWSUM?” is displayed on the LCD.
(2) Press the [▲] or [▼] to select “2.PowerOnFunc ?” and then press the [Mono Start] or
[OK]. “FUNC_ENABLE” or “FUNC_DISABLE” is displayed on the LCD.
(3) When “FUNC_DISABLE” is displayed on the LCD, the machine is at the disable state of
special function at start up. Press the [X] or [Cancel] to return to the initial state of the
maintenance mode.
When “FUNC_ENABLE” is displayed on the LCD, press the [▲] or [▼] to select
“FUNC_DISABLE” and then press the [SET] or [OK].
“1.SWSUM?” is displayed on the LCD, and the machine returns to the initial screen of the
function code 03.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
