5-6
Confidential
■ Transfer to the shipping state
< Function >
This function is to transfer the machine to the shipping state when used new spare Main PCB
for repair, etc. When not perform this function to the new spare Main PCB and leave, some
software will be unavailable such as MPS applications or BrAdmin tool. Also, the machine
keeps poor state of security such as risk of leaking private information. Do not forget to
perform this function after replacing the new spare Main PCB. However, this product does not
have function for place back to the pre-shipping state from the shipping state.
< Operating Procedure >
(1) For models with touch panel
Press the [0], and then the [3] in the initial state of maintenance mode. “1.SWSUM?” is
displayed on the LCD.
For models without touch panel
Press the [▲] or [▼] in the initial state of maintenance mode to display “MAINTENANCE
03” on the LCD, and press the [OK]. “1.SWSUM?” is displayed on the LCD.
(2) Press the [▲] or [▼] to select “3.ShippingStat?” and then press the [Mono Start] or [OK].
“ON” or “OFF: Change OK?” is displayed on the LCD.
(3) When “ON” is displayed on the LCD, the machine is at shipping state. Press the [X] or
[Cancel] to return to the initial state of the maintenance mode.
When “OFF: Change OK?” is displayed on the LCD, press the [SET] or [OK]. The
machine will transfer to the shipping state and returns to the initial state of the
maintenance mode.
Note:
Be careful that if the special function at start up in the preceding item is a valid state
([FUNC_ENABLE]), it is unable to transfer the machine to the shipping state.
Be sure to operate after changing to an invalid state ([FUNC_DISABLE]).
To Next Page
Loading...
