5-8
Confidential
1.3.4 Set worker switches (WSW) and print worker switch setting data
(Function code 10, 11)
[1] Set worker switches (Function code 10)
< Function >
The worker switches shown in the table below can be used to set the function to satisfy various
requirements. These switch settings can be changed using the keys on the control panel.
The worker switches are factory set to conform to the laws and regulations of the country the
machine is shipped to. Do not change these settings unless necessary.
* Refer to the separate manual for details of worker switches.
WSW No. Function
WSW17 selector 5 Change time display method
(American: MM/DD/YY or European: DD/MM/YY)
WSW47 selector 8 Change USB High/Full Speed
WSW49 selector 7 Change paper size select method at PDF printing
WSW55 selector 1-8 Change the Developing bias voltage correction interval
WSW56 selector 6 Change coverage type display
WSW56 selector 7 Change ON/OFF setting for PCL emulation function
WSW59 selector 1 Change ON/OFF setting for USB serial number sending
WSW63 selector 3 Change time display method
(Japanese: YY/MM/DD or others)
WSW63 selector 8 Change ON/OFF setting for Israeli font support
WSW64 selector 1-6 Language setting
WSW64 selector 7-8 Default paper size
WSW65 selector 1-2 Default media type
WSW65 selector 3 Change ON/OFF setting for Bond Paper support
WSW65 selector 4 Change ON/OFF setting for Postcard support
WSW65 selector 6 Change ON/OFF setting for Label support
WSW65 selector 7 Change ON/OFF setting for Glossy paper support
WSW81 selector 1
Change ON/OFF setting for models with PS emulation function.
WSW81 selector 2
Change ON/OFF setting for models with PCL emulation function.
To Next Page
Loading...
