9
3
3
Additional sending
options
3
Sending faxes using multiple
settings 3
When you send a fax, you can choose a
combination of settings, such as
Fax Resolution, Contrast,
Glass Scan Size, and Real Time TX.
You can also choose: Call History,
Address Book, Broadcasting, Preview,
Colour Setting, Delayed Fax,
Batch TX, Polled TX, Polling RX,
Overseas Mode, Set New Default, and
Factory Reset.
Some settings are only available when
sending mono faxes.
a Load your document.
b Do one of the following:
When Fax Preview is set to off, press
Fax.
When Fax Preview is set to on, press
Fax and then Sending Faxes.
The Touchscreen shows:
c Press Options.
d Swipe up or down, or press a or b to
display the setting you want to change.
When the setting is displayed, press it.
e Press the option you want to set.
f Go back to step d to change more
settings.
g Press OK when you have finished
changing settings.
h Enter the fax number.
i Press Fax Start.
• Most settings are temporary and the
machine returns to its default settings after
you send a fax.
• You can save some of the settings you
use most often by setting them as the
default settings. These settings will
remain until you change them again. (See
Setting your changes as a new default
on page 11.)
• You can also save some of the settings
you use most often by setting them as a
Shortcut. (See Saving fax options as a
Shortcut on page 12.)
Stop faxing 3
To stop faxing, press .
Sending a fax 3
To Next Page
Loading...
Need help?
General