Setting Up the P-touch
5
1
Inserting a Tube 1
a Press the cover open button to open the top cover.
b Pull the tube release lever up.
c Pass the tube as shown in the illustration so that the end of the tube reaches the “ ” mark on the
P-touch, and then push the tube release lever down.
d Close the top cover.
• Do not use tube which is dirty, bent, flattened, has a rough surface or uneven tube thickness, or is defective
in any other way.
• When using the P-touch, position it so direct sunlight does not enter the P-touch through the tube exit slot.
• You can use the tube half-cut adjuster to adjust the depth of half cuts to one of three settings.
• If the tube is jammed or not cut completely, use the (Feed and Cut) button to manually cut the tube
completely. Press and hold the button for 2 to 10 seconds until the (Power) indicator changes from
being lit in green to flashing in green, and then release it. The tube will be cut when the button is released.
To Next Page
Loading...
