Maintenance
66
11
b To clean the tube cutter blade, push the black portion shown in the illustration so that the blade protrudes
from the tube cutter, and then wipe the blade with a cotton swab or similar item.
Because the black portion is spring operated, be careful that your hand does not slip and contact the blade.
Do not touch the cutter blade directly with your bare hands.
c Install the tube cutter and tube cutter board in their original positions.
Replacing the Tube Cleaner 11
After repeated use, the sponge may become worn and dirty, causing poor-quality printed characters. Grab
the tube cleaner as shown in the illustration, pull it upward to remove it, and then replace it. (PA-CL-001)
To Next Page
Loading...
Need help?
General
