Printing Using the Computer
12
2
Cutting Options 2
The cutting options allow you to specify how the item is fed and cut when it is printed. Use the printer driver
to select the cutting option for tubes or tape when printing from the computer using the application. Set the
cutting line (dotted or solid line) for tubes using [Device Settings] in the [Tube Settings] tab in the "Printer
Setting Tool".
See the following table for a list of all available settings:
• You can use the tube half-cut adjuster of the P-touch to adjust the depth of half cuts to one of three
settings.
• If the tube is jammed or not cut completely, use the (Feed and Cut) button to manually cut the tube
completely. Press and hold the button for 2 to 10 seconds until the (Power) indicator changes from
being lit in green to flashing in green, and then release it. The tube will be cut when the button is released.
Tube Cut Option Table
Cut Option Description Image
No Half Cut The tubes are fully cut only after the last tube is printed.
Half Cut
The tubes are half cut in the margin before the first tube is
printed and after each of the remaining tubes is printed. The
tubes are fully cut after the last tube is printed.
Dot
A dotted line is printed in the margin before the first tube is
printed and after each of the remaining tubes is printed. The
tubes are fully cut after the last tube is printed.
Line
A solid line is printed in the margin before the first tube is
printed and after each of the remaining tubes is printed. The
tubes are fully cut after the last tube is printed.
To Next Page
Loading...
Need help?
General
