6 (55) BRUKER BIOSPIN Technical Manual Version 001
Introduction
Disclaimer 1.2
The DPP1 should only be used for its intended purpose as described in this man-
ual. Use of the DPP1 for any purpose other than that for which it is intended is tak-
en only at the users own risk and invalidates any and all manufacturer warranties.
Read this manual and pay particular attention to any safety related information
before working with the DPP1.
Safety Issues 1.3
These instructions refer to all IPSO models.
The IPSO may be damaged by inappropriate usage. The damage could be such,
that the equipment must not be used before having been checked by a service
representative.
The user should recheck the equipment at regular intervals for any damage or
wear and is expected to inform the service representative immediately of any ab
-
normality.
In the unlikely case of one of the following, stop using the equipment, disconnect
the power supply, report the circumstance to the service staff and ask for instruc
-
tions:
• The power cord, power plug or power supply are cracked, brittle or damaged.
• Signs of excessive heat are apparent.
• There is evidence or suspicion that a liquid has intruded into any enclosure.
• The power cord or the power supply have been in contact with any liquid.
• The IPSO has been dropped or damaged in any way.
• The equipment does not work correctly.
WARNING!
If you are in doubt about the correct state of any component, do not
use the equipment and inform the service staff.
WARNING!
Do not try to service the equipment by yourself, unless you are spe-
cifically asked to do so and are given instructions by the service
staff. In case of questions or problems, please contact your nearest
Bruker office or representative.
To Next Page
Loading...