7 – 16 Repair Manual RRE140/160/180/200/250 © BT
Troubleshooting
Warning and error codes
T-code Valid from serial number Date Publication No.
815, 816 6051502 2008-08-21 261828-040
The first digit of the three-digit error code indicates the severity of the
error and how the truck is affected/responds when the error occurs.
.
The error codes are subdivided into smaller categories based on the
last two digits of the code (see below).
Code
number
Error category/action taken
n:0nn
Caution. Generally an information code. No action to
be taken on the truck.
n:1nn
Warning. Some functions may be disabled or
reduced. See the specific error code to see what
action has been taken.
n:2nn
Error. All parts of the hydraulic system are disabled.
See the specific error code to see what action has
been taken.
n:3nn
Error. The truck is braked by the motor and/or the
support arm brake and/or the parking brake until it
comes to a halt. It is not possible to drive it. The
steering may be disabled if there is a steering error.
To see what action has been taken, see the specific
error code.
n:4nn
Error. The truck is braked by the motor brake until it
stops. Once the truck has stopped, or after 5 sec
-
onds, the relays for the main power supply and key
are switched off.
n:5nn
Critical error.
Main contactor and power relay for the key are
switched off.
Error code, type of error
Code
number
Description
n:n00–n09 Miscellaneous error codes.
n:n10–n19 CAN-related error codes.
n:n20–n39 Error codes related to specific units.
n:n40–n59 Error codes for short-circuited output data.
n:n60–n79 Error codes for output data from open electrical
circuits.
n:n80–n99 Faulty signals from sensors.
To Next Page
Loading...
