13 – 12 Repair Manual RRE140/160/180/200/250 © BT
Electrical system 5000
Parameter settings
T-code Valid from serial number Date Publication No.
815, 816 6051502 2008-08-21 261828-040
Driver parameter modification
The driver parameters, for the currently logged in driver, can be modi-
fied from the Driver Parameter Screen.
The screen shows a driver symbol on the top left of the screen with the
current driver profile to the right. On the middle left side of the screen is
a symbol representing the current parameter with the parameter
number displayed to the right. The bottom left side of the screen shows
a factory icon.
A row of bars shows the parameter value. The number of bars depends
on the range of parameter values. The bars are filled up to the current
parameter value.
The arrow keys are used to move the selection between:
• the parameter icon, where the ‘+’ and ‘-’ keys are used to change the
driver parameter
• the factory icon, where the parameter is restored to default value by
pressing the green key
and
• the parameter value bars.
When the parameter value bars are selected, the programmed param-
eter value is indicated by an arrow above the bar representing that val-
ue. The value is changed with the ‘+’ and ‘-’ keys and stored by pressing
the green key.
The last driver parameter is the parameter for cabin tilt height. This
parameter uses a special screen as shown below.
The height is edited by pressing the + and - keys or using the numeric
keys.
To Next Page
Loading...
