15 – 28 Repair Manual RRE140/160/180/200/250 © BT
Mast/Lift system 7000
Fork carriage
T-code Valid from serial number Date Publication No.
815, 816 6051502 2008-08-21 261828-040
15.5 Fork carriage
15.5.1 Checking the fork carriage’s wear strip
The wear strip (a) between the yoke and ball beam on the fork carriage
is subject to wear and must be checked annually.
1. Measure the gap (b) between the yoke and the ball beam. When
the wear strip is new, the gap is 2 mm. If the gap is 4 mm or more,
the wear strip must be replaced.
2. Check the gap (c) between the stop lug and the fork yoke as well.
On maximum upward tilt angle, play should be a maximum of 1
mm.
3. Place a 1 mm feeler gauge between the fork yoke and stop lug to
check and adjust the distance. The feeler gauge can be removed
once the forks have been tilted down. Tighten the four screws to
45
±11 Nm.
4. The gap can be adjusted with the screws on the stop lug (see the
screws marked with arrows).
a: Maximum tilt angle
a
C
Max tilt angle
a
To Next Page
Loading...
