Drive gear 2000
General
Publication No. Date Valid from serial number T-code
261828-040 2008-08-21 6051502 815, 816
© BT Repair Manual RRE140/160/180/200/250 10 – 5
10.1.3 Replacing the pinion gear, input shaft
Remove the pinion gear
1. Use a screwdriver to remove the seal (a). Be careful with the sur-
face of the seal on its drive gear side.
2. Remove the locking ring (b).
3. Extract the pinion gear (d) from the gear housing using tool
257421.
- Tighten the nut on the puller. The nut opens out the claws of the
puller.
- Give a few powerful upward pulls on the handle of the puller to
loosen the pinion gear.
- Carefully lift out the pinion gear (d) to avoid damaging the teeth.
- Loosen the nut on the puller to release the pinion gear.
4. Pull the bearing (c) off the pinion gear with a claw puller.
a. Seal
b. Locking ring
c. Bearing
d. Pinion gear
e. Sealing ring
a
d
e
c
b
To Next Page
Loading...
